Skip to content

How Do You Make Sous Vide Garlic Butter Sirloin Steak?

By Brett Murphy ·

6 min read

Sous vide garlic butter sirloin steak is made by cooking a sealed steak in a temperature-controlled water bath, drying its surface and finishing it with a quick sear in a hot skillet. A spoonful of freshly prepared garlic herb butter adds richness to the lean cut of beef. The method helps produce a more evenly cooked interior than relying on a hot skillet alone. For this version, the water bath is set to 150°F, and the steaks are checked with a food thermometer before serving.

Recipe at a Glance

Servings: four. Preparation time: 15 minutes. Water bath cooking time: approximately two to three hours for thawed steaks about one to one and a half inches thick. Finishing time: 10 minutes. Equipment: immersion circulator, heat-safe water bath container, food-safe sous vide bags, tongs, cast iron skillet and instant-read thermometer. Follow the equipment manufacturer’s instructions for filling, operation and safe cooking times.

Ingredients for Garlic Butter Sirloin Steak

Gather four boneless top sirloin steaks, approximately six ounces each and one to one and a half inches thick; one teaspoon fine salt, half a teaspoon freshly ground black pepper and one tablespoon neutral high-heat cooking oil. For the garlic herb butter, use four tablespoons unsalted butter, two cloves garlic minced, one tablespoon chopped fresh parsley and one teaspoon chopped fresh thyme or rosemary. An optional squeeze of fresh lemon juice can brighten the butter. Choose whole, intact steaks rather than mechanically tenderized or injected meat for this recipe.

What Is Sous Vide Cooking?

Sous vide involves enclosing food in a suitable bag and cooking it in water maintained at a controlled temperature. An immersion circulator heats and moves the water so that it stays close to the selected setting. Since the water is much cooler than a typical oven or skillet, the outer portions of the steak tend to cook more gently while heat gradually reaches the center. The water bath itself will not produce the browned crust associated with grilled or pan-seared steak. A separate searing step is therefore important for flavor and texture.

Choosing the Right Sirloin Steak

Top sirloin generally offers a good balance of beef flavor and leanness. Select steaks with similar thickness so that heat reaches their centers at approximately the same rate. Look for a small amount of marbling and trim unusually large pieces of exterior fat if desired. Thin steaks can overcook during the final sear, while very thick steaks require different water bath cooking times. Read the packaging carefully: mechanically tenderized, rolled, stuffed and ground beef products require appropriate product-specific food safety guidance and are not interchangeable with intact steaks.

Step 1: Prepare the Water Bath

Fill a suitable heat-safe container with water within the minimum and maximum levels specified by your immersion circulator. Attach the equipment securely and set the water temperature to 150°F. Wait for the water to reach the selected temperature before adding the meat. Place the container on a stable, heat-resistant surface away from the edge of the counter. Do not allow the water level to fall below the minimum during cooking. A compatible lid may reduce evaporation, provided it does not interfere with the circulator.

Step 2: Season and Seal the Steaks

Pat the thawed steaks dry with paper towels and season both sides lightly with salt and pepper. Place them in individual heat-rated food-safe sous vide bags or arrange them in a single layer in a sufficiently large bag. Seal according to the bag manufacturer’s directions. Remove excess air so that the meat remains submerged and water can circulate around it. Do not stack the steaks inside the bag because that effectively increases the thickness through which heat must travel. Keep the raw meat refrigerated until you are ready to begin the water bath.

Step 3: Cook the Steaks Sous Vide

Lower the sealed bags into the preheated water bath. Make sure the meat is fully submerged and the bags do not block circulation. Cook the thawed steaks for approximately two to three hours at 150°F, using the longer end for thicker pieces within the recipe’s specified range. Cooking time is an estimate, not a guarantee of doneness. The USDA recommends an internal temperature of at least 145°F for beef steaks, followed by a minimum three-minute rest. Check the thickest area with an instant-read thermometer after removing the steak from its bag. If the center has not reached the required temperature, finish cooking in the skillet or oven and verify the temperature again. Follow package directions if a higher cooking temperature is required.

Step 4: Prepare the Garlic Herb Butter

Melt four tablespoons of butter in a small saucepan over low heat. Add the minced garlic and cook gently for about thirty to sixty seconds, stirring until fragrant without letting the garlic brown. Remove the saucepan from the heat and stir in the parsley and thyme or rosemary. Add a little fresh lemon juice if desired. Preparing the garlic butter separately gives you more control over the flavor and prevents the garlic from burning in the high-heat searing pan. Use the butter freshly prepared rather than storing homemade garlic-infused butter at room temperature.

Step 5: Dry the Steaks Thoroughly

Use tongs to lift the bags from the water bath. Open them carefully, avoiding the hot liquid. Transfer the meat to a clean plate and use a thermometer to check its internal temperature. Discard the bag liquid if it is not needed. Pat the steaks thoroughly dry with fresh paper towels. Removing surface moisture is essential, since excess water must evaporate before the surface can brown effectively. Use a clean plate and utensils for the cooked beef rather than reusing those that contacted raw meat.

Step 6: Sear and Finish With Garlic Butter

Heat a heavy skillet over medium-high to high heat and add a thin layer of neutral oil. Working in batches if necessary, sear the steaks for approximately thirty to sixty seconds per side, or until a golden-brown crust develops. Briefly sear the edges if desired. Turn down the heat or remove the skillet from the burner before adding the prepared garlic butter. Check that the steaks meet the safe internal temperature, then transfer to a clean plate and rest for at least three minutes. Spoon the warm garlic butter over the meat just before serving.

Serving Suggestions and Variations

Garlic butter sirloin pairs well with roasted potatoes, green beans, grilled asparagus or a simple garden salad. For a different herb profile, replace thyme with chopped rosemary or use fresh chives. A little lemon zest adds a brighter flavor, while a pinch of smoked paprika adds warmth. Slice the steak thinly across the grain for sandwiches or salads, which helps shorten the muscle fibers and makes the lean sirloin easier to chew.

Storage and Reheating

Serve the freshly cooked steak promptly. Remove leftovers from the sous vide bags and refrigerate in shallow covered containers within two hours, or within one hour above 90°F. Use refrigerated leftovers within three to four days and reheat to 165°F. Do not assume that a vacuum-sealed cooked steak can safely be stored for longer than ordinary leftovers; extended sous vide storage requires validated rapid chilling and temperature controls.

Frequently Asked Questions

Can I skip the sear?

Yes, if the steak is safely cooked, but the final sear adds a flavorful crust.

Why is my steak not browning?

Surface moisture or an insufficiently hot skillet may be responsible. Dry the steak well before searing.

Can I cook frozen steaks?

Thaw them safely in the refrigerator first for this recipe. Frozen steaks require different heating times.

Final Tips

Use evenly sized intact steaks, verify the internal temperature and finish with a short sear. Add garlic butter after browning for the best aroma.

Frequently Asked Questions

What Is Sous Vide Cooking?

Sous vide involves enclosing food in a suitable bag and cooking it in water maintained at a controlled temperature. An immersion circulator heats and moves the water so that it stays close to the selected setting. Since the water is much cooler than a typical oven or skillet, the outer portions of the steak tend to cook more gently while heat gradually reaches the center. The water bath itself will not produce the browned crust associated with grilled or pan-seared steak. A separate searing step is therefore important for flavor and texture.

Can I skip the sear?

Yes, if the steak is safely cooked, but the final sear adds a flavorful crust.

Why is my steak not browning?

Surface moisture or an insufficiently hot skillet may be responsible. Dry the steak well before searing.

Can I cook frozen steaks?

Thaw them safely in the refrigerator first for this recipe. Frozen steaks require different heating times.

Topics:

Leave a Reply